User Guide
Table Of Contents
- Setting up the TI‑Nspire™ Navigator™ Teacher Software
- About the Hardware
- Before You Begin
- Charging the Cradles
- Updating the Handheld Operating System
- Connecting the TI‑Nspire™ Navigator™ Access Point
- Confirming Handheld OS Version
- Naming the Class Network
- Adding Wireless Clients to the Network
- Connecting the Handhelds to the Wireless Adapters
- Connecting the Handhelds to Cradles
- Creating and Managing Your Teacher Account
- Logging In to the TI‑Nspire™ Navigator™ System from the Handheld
- Storing the Wireless Adapters and Cradles
- Using TI‑Nspire™ Network Manager
- USA FCC Information Concerning Radio Frequency Interference
- Canadian IC Information
- Mexico - Declaration of Conformity
- European Union and EFTA Regulatory Compliance
- China SRRC CMIIT Identification
- Warning Statements
- Important for Safe AC Adapter Operation
Before You Begin
When you launch a new version of the TI-Nspire™ Navigator™ Teacher
Software for the first time, the TI-Nspire™ Navigator™ System Startup wizard
opens and guides you through the automated process to set up your wireless
classroom. Before you begin the wireless set up process:
• Make sure you have installed and activated the TI-Nspire™ Navigator™
Teacher Software on your computer.
• If you are using TI-Nspire™ Navigator™ wireless cradles, make sure each
cradle is charged ( LEDis solid amber or solid green).
Note:If you are using TI-Nspire™ wireless network adapters, you do not
need to charge them. The wireless network adapters are powered by the
handhelds.
• Disconnect the TI-Nspire™ Navigator™ access point or TI-Nspire™ CX
Navigator™ access point from your computer.
Automated System Startup
When you launch the software, the Startup wizard will guide you through the
steps needed to:
• Update all student and classroom handhelds to the latest operating system
(OS)version. The OS on the handhelds must match the software version
installed on your computer.
Important! When updating the OS, handhelds must be connected to the
computer using a USB cable or TI-Nspire™ CXDocking Station.
• Connect the access point and, if needed, update the access point
firmware.
• Name the class network.
• If required, select a channel for the access point.
• Add wireless clients to your network.
• Create a backup copy of the class network configuration.
Setting up the TI-Nspire™ Navigator™ Teacher Software 3
DRAFT