User Guide
Table Of Contents
- Setting up the TI‑Nspire™ Navigator™ Teacher Software
- About the Hardware
- Before You Begin
- Charging the Cradles
- Updating the Handheld Operating System
- Connecting the TI‑Nspire™ Navigator™ Access Point
- Confirming Handheld OS Version
- Naming the Class Network
- Adding Wireless Clients to the Network
- Connecting the Handhelds to the Wireless Adapters
- Connecting the Handhelds to Cradles
- Creating and Managing Your Teacher Account
- Logging In to the TI‑Nspire™ Navigator™ System from the Handheld
- Storing the Wireless Adapters and Cradles
- Using TI‑Nspire™ Network Manager
- USA FCC Information Concerning Radio Frequency Interference
- Canadian IC Information
- Mexico - Declaration of Conformity
- European Union and EFTA Regulatory Compliance
- China SRRC CMIIT Identification
- Warning Statements
- Important for Safe AC Adapter Operation
5. Click Finish to complete the TI-Nspire™ Navigator™ System setup.
Note:You can add more wireless adapters or cradles to the class network at a
later time using the TI-Nspire™ NetworkManager.
Connecting the Handhelds to the Wireless Adapters
The wireless network adapters work with the TI-Nspire™ CX and TI-Nspire™ CX
CAS handhelds. To connect the handheld to a wireless adapter, follow these
steps.
1. Position the wireless adapter on top of the handheld so the connector on
the adapter lines up with the connector on top of the handheld.
À
Connector
Á
Guides for aligning with handheld
Â
Grooves to align wireless adapter
2. Slide the adapter into position, making sure the guides on the sides of the
adapter slide into the grooves on the sides of the handheld.
3. Firmly press the adapter into place.
Setting up the TI-Nspire™ Navigator™ Teacher Software 19
DRAFT