User's Manual

202
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: The TI-Navigator™ Access Point, TI-Nspire™ Navigator™
Cradle, and TI-Nspire™ CX Wireless Network Adapter comply with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) These devices may not cause harmful interference, and (2) these
devices must accept any interference received, including interference
that may cause undesired operation.
RF Radiation Exposure and Hazard Statement:
To ensure compliance with FCC RF exposure requirements, the
TI-Navigator™ access point must be installed in a location such that the
antenna of the device will be greater than 20 cm (7.9 inches) away from
all persons. Using higher gain antennas and types of antennas not
covered under the FCC certification of this product is not allowed.
Installers of the radio and end users of the product must adhere to the
installation instructions provided in this manual.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Non-modification Statement:
Use only the integral antenna supplied by the manufacturer when
operating these devices. Unauthorized antennas, modifications, or
attachments could damage the TI-Navigator™ Access Point, TI-Nspire™
CX Wireless Network Adapter, or TI-Nspire™ Navigator™ Cradle and
violate FCC regulations. Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate this equipment.
Deployment Statement:
This product is certified for indoor deployment only. Do not install or use
this product outdoors.