User's Manual

10 Installing the TI-Nspire™ Navigator™ software
Installing the TI-Nspire™ Navigator™ software
To install software on your computer, you must have administrator
privileges when you log in to the Windows
®
operating system. If you
don’t know whether or not you have administrator privileges, check with
your school’s help desk or system administrator.
1. Insert the TI-Nspire™ Navigator™ CD in your computer’s CD-ROM
drive. The window to the CD should open automatically.
Note: If your computer is running Windows® XP Service Pack 2, you
may see the following message. If so, click
Yes to continue.
Note: If the setup program does not run, click Start > Run, and then
type D:\Autorun.exe, where D is your CD-ROM drive, and click OK.
2. Click TI-Nspire Navigator Software, and then click Install
TI-Nspire™ Navigator™
Software.
The TI-Nspire™ Navigator™ Setup dialog displays.
Separate installations will occur:
– TI-Nspire™ Navigator™ software
– TI-Nspire™ Teacher software and TI-Nspire™ CAS Teacher
software. Refer to the TI-Nspire™ Teacher software user guide,
included with your system, for more information about the
TI-Nspire™ Teacher software.
3. When the installation is complete, the TI-Nspire™ Navigator™ Setup
dialog displays the status of installed components.
• If you have already purchased the software, click
Activate this
software
, and then click Next. Follow the instructions on the screen
to activate the software.
• If you have not purchased the software, click Continue with trial
version
. The screen displays how many days remain in your trial
period.
• If you have been using the trial version and would like to purchase
the software, click
Purchase software. You can complete the
TI-Navigator_Help_PRINT.book Page 10 Tuesday, January 26, 2010 10:29 AM