User's Manual

Installing the TI-Nspire™ Navigator™ software 5
With five wireless cradles in the charging bay, you should charge them
for 12 hours. Typically this is done overnight or over a weekend.
Note: You cannot damage the batteries by leaving them in the charging
bay beyond the time needed to fully charge them. Also, it is not
necessary to fully discharge the batteries before recharging them.
1. Make sure you have enough (3–4) power outlets for the equipment
you received. If necessary, obtain a plug strip so that you have plenty
of grounded outlets.
2. Insert the small end of the AC9940 power adapter cord into the
charging bay’s power jack.
3. Plug the other end of the adapter into a power outlet.
4. Insert each TI-Nspire™ Navigator™ wireless cradle into the
TI-Nspire™ Navigator™ cradle charging bay. Make sure the LED is
amber.
Note: If you purchased the individual kit and do not have a cradle
charging bay, you can charge a single wireless cradle using the AC9926
adapter instead.
Checking the LEDs
Two LEDs (small lights) at the top of each TI-Nspire™ Navigator™
wireless cradle blink or change colors to indicate various operations or
status.
The LED indicates network activity. The LED indicates battery-
charging status. (For more information, see the Technical Information
chapter.)
LEDs
TI-Navigator_Help_PRINT.book Page 5 Tuesday, January 26, 2010 10:29 AM