User Manual

27
The device did
not respond, or
cradle is not listed
in the Network
Manager window.
• Refresh the network status. After checking
for the previous conditions, refresh the status
screen to see if the cradle has been detected.
• Make sure the cradle’s battery is fully charged
or verify that the power adapter is connected.
• Make sure the cradle is within range of the
access point.
• When in the process of adding cradles, be
patient. It may take up to 30 seconds after
resetting a cradle before it is recognized and
configured by the software.
• Sometimes you must choose a different
channel to avoid interference and improve
reception. If you changed the channel, try
removing all the cradles and then adding all
the cradles back into the network.
• If more than one network is located in the
same area, cradles sometimes associate with
the wrong access point. To avoid this, make
sure that cradles are added to only one
TI-Nspire™ Navigator™ system at a time, and
make sure a TI-Nspire™ Navigator™ system in
a nearby classroom is not adding cradles at
the same time.
Communication
Error
One or more
cradles is not
communicating
with the access
point.
• To restore communication between the cradle
and access point, click
View > Refresh.
• If the error message remains, select the
cradles that are not working, remove them
from the network, and then add them back
into the network.
Problem or
message
Possible causes or solutions