User Manual

21
If possible, avoid sources of potential interference, such as metal walls,
microwave ovens, and wireless phones.
Access point LEDs
POWER – Indicates that the access point is receiving power from the
power adapter.
TEST – The access point is in self-test mode. This LED should blink for a
minute and then stop.
STATUS: 100 LINK/ACT – Indicates data transfer.
SIGNAL: 802.11 b/g – Indicates wireless link activity.
Battery information for wireless cradles
• You cannot damage the batteries by leaving them in the charging
bay beyond the time needed to fully charge them. Also, you will not
damage the wireless cradles by inserting or removing them from the
charging bay at any time.
• It is not necessary to unplug the power adapter from the charging
bay, even when no wireless cradles are present.
• To charge as many as five wireless cradles at a time, use the charging
bay. If you only need to charge one cradle, you can connect the
AC9926 power adapter directly from the cradle to a power outlet.
• It is not necessary to fully discharge the batteries before recharging
them.
• Do not leave the wireless cradles in an extremely cold or extremely
warm location, such as inside an automobile in hot weather.
• Every few weeks, you should clean the electrical contacts on the
charging bay and the wireless cradles using a clean, dry cloth.
Storing the wireless cradles
If you need to store the TI-Nspire™ Navigator™ wireless cradles for more
than two weeks:
• Store the cradles in a cool, dry place.
• Fully charge the cradles at least once every 10-12 months.