User Manual
Table Of Contents
- Setting Up the TI-Nspire™ Navigator™ Teacher Software
- Unpacking the Boxes
- Charging the Cradles
- Installing the Handheld Software
- Setting Up a TI-Nspire™ Navigator™ Network the First Time
- Connecting the Handhelds to the Wireless Adapters
- Connecting the Handhelds to Cradles
- Storing the Wireless Adapters and Cradles
- Checking the Status of Wireless Adapters and Cradles
- Creating and Managing Your Teacher Account
- Logging In to the TI-Nspire™ Navigator™ System from the Handheld
- USA FCC Information Concerning Radio Frequency Interference
- Canadian IC Information
- Warning Statements
Setting Up the TI-Nspire™ Navigator™ Teacher Software 7
Before you Begin
• Make sure you have installed and activated the TI-Nspire™
Navigator™ Teacher Software on your computer.
• If you are using TI-Nspire™ Navigator™ Cradles, make sure each
cradle is charged ( LED is solid amber or solid green).
Note: If you are using TI-Nspire™ Wireless Network Adapters, you do
not need to charge them. The wireless network adapters are powered
by the TI-Nspire™ CX or TI-Nspire™ CX CAS handheld.
• Make sure all handhelds have the latest operating system installed.
Connecting the Access Point to the Computer
The TI-Nspire™ Navigator™ Access Point is powered by your computer.
When you connect the access point to your computer, it is powered on
and ready to communicate with wireless network adapters and cradles.
1. Connect the small end of the USB cable to the access point.
2. Connect the other end of the cable to the USB port on your computer.
3. Make sure the access point power light is on.
The power light indicates that the access point is receiving power from
the computer. The signal light indicates wireless link activity.
Starting the Wizard
When installation of the TI-Nspire™ Navigator™ Teacher Software is
complete, open TI-Nspire™ Network Manager to set up your system.
To open Network Manager, click
Tools > Network Manager.
A setup wizard helps you through the next steps.
Note: You can run the setup wizard later by opening TI-Nspire™
Network Manager and clicking
Actions > Network Setup Wizard.
1. Plug one end of the USB cable into the access point, and the other
end into the computer.
USB connection
Power light
Signal light