Operation Manual

Chapter 12: Statistics 221
2. Select the plot to define, which pastes Plot1(, Plot2(, or Plot3( to the cursor location.
3. Press y , ~ to display the
STAT TYPE menu.
4. Select the type of plot, which pastes the name of the plot type to the cursor location.
5. Press ¢. Enter the list names, separated by commas.
6. Press ¢ y , | to display the
STAT PLOT MARK menu. (This step is not necessary if you
selected 3:Histogram or 5:Boxplot in step 4.)
Select the type of mark (› or
+ or ¦) for each data point. The selected mark symbol is pasted to the
cursor location.
7. Press ¤ Í to complete the command line.
Displaying a Stat Plot from a Program
To display a plot from a program, use the DispGraph instruction (Chapter 16) or any of the ZOOM
instructions (Chapter 3).