Operation Manual

Chapter 19: Communication Link 344
2. Select the menu item that describes the data type to send. The corresponding SELECT screen is
displayed.
3. Press } and † to move the selection cursor ( 4 ) to an item you want to select or deselect.
4. Press Í to select or deselect the item. Selected names are marked with a 0.
Note: An asterisk (ä) to the left of an item indicates the item is archived.
5. Repeat steps 3 and 4 to select or deselect additional items.
Sending the Selected Items
After you have selected items to send on the sending unit and set the receiving unit to receive, follow
these steps to transmit the items. To set the receiving unit, see Receiving Items.
1. Press ~ on the sending unit to display the
TRANSMIT menu.
2. Confirm that
Waiting... is displayed on the receiving unit, which indicates it is set to receive.
3. Press Í to select 1:Transmit. The name and type of each item are displayed line-by-line on the
sending unit as the item is queued for transmission, and then on the receiving unit as each item is
accepted.
Note: Items sent from the RAM of the sending unit are transmitted to the RAM of the receiving
unit. Items sent from user data archive (flash) of the sending unit are transmitted to user data
archive (flash) of the receiving unit.
After all selected items have been transmitted, the message
Done is displayed on both calculators. Press
} and † to scroll through the names.
Sending to a TI-84 Plus C Silver Edition, TI-84 Plus Silver Edition, TI-84 Plus
See section Linking Compatibility in this chapter for information on files and variables that can be
transferred.
Note: Keep in mind that the TI-84 Plus has less Flash memory than the TI-84 Plus C Silver Edition.
• Variables stored in RAM on the sending graphing calculator will be sent to the RAM of the
receiving graphing calculator.
• Variables and applications stored in the user data archive of the sending graphing calculator will be
sent to the user data archive of the receiving graphing calculator.
After sending or receiving data, you can repeat the same transmission to additional graphing calculator
units—from either the sending unit or the receiving unit—without having to reselect data to send. The
current items remain selected. However, you cannot repeat transmission if you selected
All+ or All..
To send data to an additional graphing calculators:
1. Use a USB unit-to-unit cable to link two units together.