Datasheet

THS8200
SLES032D –JUNE 2002–REVISED JUNE 2013 www.ti.com
csm_shift_bcb_on: B/Cb shifting on/off
{csm_rcr_bcb_cntl 0x4F(4)} [0]
0 : Shifting for B/Cb channel off
1 : Shifting for B/Cb channel on
csm_rcr_high_clip_on: R/Cr high-end clipping on/off
{csm_rcr_bcb_cntl 0x4F(3)} [0]
0 : R/Cr data clipping at high end off
1 : R/Cr data clipping at high end on
csm_rcr_low_clip_on: R/Cr low-end clipping on/off
{csm_rcr_bcb_cntl 0x4F(2)} [0]
0 : R/Cr data clipping at low end off
1 : R/Cr data clipping at low end on
csm_bcb_high_clip_on: B/Cb high-end clipping on/off
{csm_rcr_bcb_cntl 0x4F(1)} [0]
0 : B/Cb data clipping at high end off
1 : B/Cb data clipping at high end on
csm_bcb_low_clip_on: B/Cb low-end clipping on/off
{csm_rcr_bcb_cntl 0x4F(0)} [0]
0 : B/Cb data clipping at low end off
1 : B/Cb data clipping at low end on
5.2.8 Display Timing Generator Control, Part 2 (Sub-Addresses 0x50−0x82)
dtg2_bp<n>(10:0): breakpoint<n> line number
{see register map table} [000 0000 0000]
DTG outputs line type dtg2_linetype<n> until line number of dtg2_bp<n+1> is reached. (n = 1..16)
dtg2_linetype<n>(3:0): Line type for dtg2_bp<n>
{see register map table} [0000]
The DTG outputs a line format corresponding to the table below until the next breakpoint line number is reached. (n = 1..16)
LINE TYPE MODE
0000 ACTIVE_VIDEO
0001 FULL_NTSP
0010 FULL_BTSP
0011 NTSP_NTSP
0100 BTSP_BTSP
0101 NTSP_BTSP
0110 BTSP_NTSP
0111 ACTIVE_NEQ
1000 NSP_ACTIVE
1001 FULL_NSP
1010 FULL_BSP
1011 FULL_NEQ
1100 NEQ_NEQ
1101 BSP_BSP
1110 BSP_NEQ
1111 NEQ_BSP
74 Copyright © 2002–2013, Texas Instruments Incorporated
I
2
C Registers
Submit Documentation Feedback
Product Folder Links: THS8200