Datasheet

www.ti.com
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
THS6182
SLLS544H – SEPTEMBER 2002 – REVISED JUNE 2007
over operating free-air temperature range unless otherwise noted
(1)
ELECTRICAL THS6132
V
CC
Supply voltage ± 16.5 V
V
I
Input voltage ± V
CC
I
O
Output current 1000 mA
V
IO
Differential input voltage ± 2 V
THERMAL
Maximum junction temperature, any condition 150 ° C
T
J
Maximum junction temperature, continuous operation, long term reliability
(2)
125 ° C
T
stg
Storage temperature 65 ° C to 150 ° C
ESD
HBM 2000 V
ESD ratings CDM 1500 V
MM 200 V
(1) The absolute maximum ratings under any condition is limited by the constraints of the silicon process. Stresses above these ratings may
cause permanent damage. Exposure to absolute-maximum-rated conditions for extended periods may degrade device reliability. These
are stress ratings only, and functional operation of the device at these or any other conditions beyond those ispecified is not implied.
(2) The maximum junction temperature for continuous operation is limited by package constraints. Operation above this temperature may
result in reduced reliability and/or lifetime of the device.
over recommended operating free-air temperature range, T
A
= 25 ° C, V
CC
= ± 12 V, R
F
= 2 k Ω ,
Gain = +5, I
ADJ
= Bias1 = Bias2 = 0 V, R
L
= 50 Ω (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
NOISE/DISTORTION PERFORMANCE
Gain = +9.5, 163 kHz to 1.1 MHz DMT,
MTPR Multitone power ratio -76 dBc
+20 dBm Line Power, See Figure 1 for circuit
Gain =+5, 25 kHz to 138 kHz with MTPR signal applied,
Receive band spill-over -95 dBc
See Figure 1 for circuit
Differential load = 200 Ω -88
dBc
2
nd
harmonic
Differential load = 50 Ω -70
Harmonic distortion, V
O(PP)
= 2 V
HD
f = 1 MHz
Differential load = 200 Ω -107
dBc
3
rd
harmonic
Differential load = 50 Ω -84
V
n
Input voltage noise V
CC
= ± 5 V, ± 12 V, ± 15 V, f = 100 kHz 3.2 nV/ √ Hz
+Input 1.5
I
n
Input current noise V
CC
= ± 5 V, ± 12 V, ± 15 V, f = 100 kHz pA/ √ Hz
-Input 10
R
L
= 100 Ω -65 dBc
f = 1 MHz, V
O(PP)
= 2 V,
Crosstalk
V
CC
= ± 5 V, ± 12 V, ± 15 V
R
L
= 25 Ω -60 dBc
3
Submit Documentation Feedback