Datasheet

THS4211
THS4215
SLOS400E –SEPTEMBER 2002–REVISED SEPTEMBER 2009 ................................................................................................................................... www.ti.com
TYPICAL CHARACTERISTICS
Table of Graphs (±5 V)
FIGURE
Small-signal unity-gain frequency response 1
Small-signal frequency response 2
0.1-dB gain flatness frequency response 3
Large-signal frequency response 4
Slew rate vs Output voltage 5
Harmonic distortion vs Frequency 6, 7, 8, 9
Harmonic distortion vs Output voltage swing 10, 11, 12, 13
Third-order intermodulation distortion vs Frequency 14, 16
Third-order output intercept point vs Frequency 15, 17
Voltage and current noise vs Frequency 18
Differential gain vs Number of loads 19
Differential phase vs Number of loads 20
Settling time 21
Quiescent current vs supply voltage 22
Output voltage vs Load resistance 23
Frequency response vs Capacitive load 24
Open-loop gain and phase vs Frequency 25
Open-loop gain vs Case temperature 26
Rejection ratios vs Frequency 27
Rejection ratios vs Case temperature 28
Common-mode rejection ratio vs Input common-mode range 29
Input offset voltage vs Case temperature 30
Input bias and offset current vs Case temperature 31
Small-signal transient response 32
Large-signal transient response 33
Overdrive recovery 34
Closed-loop output impedance vs Frequency 35
Power-down quiescent current vs Supply voltage 36
Power-down output impedance vs Frequency 37
Turn-on and turn-off delay times 38
8 Submit Documentation Feedback Copyright © 2002–2009, Texas Instruments Incorporated
Product Folder Link(s): THS4211 THS4215