Datasheet

THS4062 EVM Differential Input
1-11
General
1.7 THS4062 EVM Differential Input
The THS4062 EVM is shipped preconfigured for dual-channel, single-ended
noninverting operation. It can be reconfigured for single-channel, differential
operation, either noninverting or inverting.
1.7.1 Differential Input, Noninverting Operation
Configure the THS4062 EVM for differential noninverting operation by
removing two resistors and adding a resistor on the board:
1) Remove resistors R1 and R9.
2) Add a 100-Ω resistor to the R8 location on the board.
This configuration (noninverting) is shown in Figure 1–4. For a noninverting
differential input, R8 should be 100 Ω to match 50-Ω source impedances. Note
that compensation capacitors C3 and C6 are not installed.
Figure 1–4. THS4062 EVM Schematic — Differential Input (Noninverting Operation)
–
+
U1:A
THS4062
1
4
8
2
3
R3
0 Ω
R6
301 Ω
+VCC
C3
x µF
R7
49.9 Ω
Vout1
J3
C4
0.1 µF
–VCC
J1
Vin1
R8
100 Ω
–
+
U1:B
THS4062
7
6
5
R11
0 Ω
R14
301 Ω
C6
x µF
R15
49.9 Ω
Vout2
J5
J4
Vin2
C5
0.1 µF
R5
301 Ω
R13
301 Ω
C1
6.8 µF
–VCC
1
GND
2
+VCC
3
J2
C2
6.8 µF
–VCC
+VCC