Datasheet

THS3202

www.ti.com

SLOS242F –SEPTEMBER 2002–REVISED JANUARY 2010

TYPICAL CHARACTERISTICS

Table of Graphs

FIGURE

Small-signal frequency response Figure 1-Figure 14

Large-signal frequency response Figure 15-Figure 18

Harmonic distortion vs Frequency Figure 19-Figure 24

Harmonic distortion vs Output voltage Figure 25-Figure 32

IMD3 vs Frequency Figure 33, Figure 34

OIP3 vs Frequency Figure 35, Figure 36

Test circuit for IMD3/OIP3 Figure 37

S-parameter vs Frequency Figure 38-Figure 41

Input current noise density vs Frequency Figure 42

Voltage noise density vs Frequency Figure 43

Transimpedance vs Frequency Figure 44

Output impedance vs Frequency Figure 45

Impedance of inverting input Figure 46

Supply current/channel vs Supply voltage Figure 47

Input offset voltage vs Free-air temperature Figure 48

Offset voltage vs Common-mode input voltage range Figure 49

vs Free-air temperature Figure 50

Input bias current

vs Input common-mode range Figure 51

Positive power-supply rejection ratio vs Positive power supply Figure 52

Negative power-supply rejection ratio vs Negative power supply Figure 53

Positive output voltage swing vs Free-air temperature Figure 54, Figure 55

Negative output voltage swing vs Free-air temperature Figure 56, Figure 57

Output current sinking vs Power supply Figure 58

Output current sourcing vs Power supply Figure 59

Overdrive recovery time Figure 60, Figure 61

Slew rate vs Output voltage Figure 62-Figure 64

Output voltage transient response Figure 65

Settling time Figure 66, Figure 67

DC common-mode rejection ratio high vs Input common-mode range Figure 68

Power-supply rejection ratio vs Frequency Figure 69, Figure 70

Differential gain error vs 150-Ω loads Figure 71, Figure 72, Figure 75

Differential phase error vs 150-Ω loads Figure 73, Figure 74, Figure 76

Product Folder Link(s): THS3202