Datasheet

TYPICAL CHARACTERISTICS
Table of Graphs (V
S
= ± 7.5 V)
THS3201-EP
www.ti.com ..................................................................................................................................................... SGLS283B – APRIL 2005 – REVISED JANUARY 2009
FIGURE NO.
Noninverting small-signal frequency response 2, 3
Inverting small-signal frequency response 4
Inverting large-signal frequency response 5, 6
0.1-dB gain flatness frequency response 7
Capacitive load frequency response 8
Recommended switching resistance vs Capacitive load 9
2nd harmonic distortion vs Frequency 10
3rd harmonic distortion vs Frequency 11
2nd-order harmonic distortion, G = 2 vs Output voltage 12
3rd-order harmonic distortion, G = 2 vs Output voltage 13
2nd-order harmonic distortion, G = 5 vs Output voltage 14
3rd-order harmonic distortion, G = 5 vs Output voltage 15
2nd-order harmonic distortion, G = 10 vs Output voltage 16
3rd-order harmonic distortion, G = 10 vs Output voltage 17
3rd-order intermodulation distortion (IMD
3
) vs Frequency 18
S-Parameter vs Frequency 19, 20
Input voltage and current noise vs Frequency 21
Noise figure vs Frequency 22
Transimpedance vs Frequency 23
Input offset voltage vs Case temperature 24
Input bias and offset current vs Case temperature 25
Slew rate vs Output voltage 26
Settling time 27, 28
Quiescent current vs Supply voltage 29
Output voltage vs Load resistance 30
Rejection ratio vs Frequency 31
Noninverting small-signal transient response 32
Inverting large-signal transient response 33
Overdrive recovery time 34
Differential gain vs Number of loads 35
Differential phase vs Number of loads 36
Closed-loop output impedance vs Frequency 37
Copyright © 2005 – 2009, Texas Instruments Incorporated Submit Documentation Feedback 9
Product Folder Link(s): THS3201-EP