Datasheet

THS3061
THS3062
www.ti.com SLOS394B –JULY 2002–REVISED NOVEMBER 2009
ELECTRICAL CHARACTERISTICS (continued)
At V
S
= ±5 V: R
f
= 560 Ω, R
L
= 150 Ω , and G = 2, unless otherwise noted.
THS3061, THS3062
TYP OVER TEMPERATURE
PARAMETER TEST CONDITIONS
–40°C MIN/
0°C to
+25°C +25°C to UNITS TYP/
+70°C
+85°C MAX
Current output, sourcing 63 61 60 59 mA Min
R
L
= 50 Ω
Current output, sinking –63 –61 –60 –59 mA Min
Closed-loop output impedance G = 1, f = 1 MHz 0.1 Ω Typ
POWER SUPPLY
Specified operating voltage ±5 V Typ
Minimum operating voltage ±4.5 ±4.5 ±4.5 V Min
Maximum quiescent current 6.3 8.0 9.2 9.5 mA Max
Minimum quiescent current 6.3 5.0 4.7 4.6 mA Min
Power-supply rejection (+PSRR) V
S+
= 4.50 V to 5.50 V 73 65 63 63 dB Min
Power-supply rejection (–PSRR) V
S–
= –4.50 V to –5.50 V 75 65 63 63 dB Min
space
space
space
TYPICAL CHARACTERISTICS
Table of Graphs
FIGURE
Small-signal frequency response 3-14
Large-signal frequency response 15, 16
Harmonic distortion vs Frequency 17-23
Harmonic distortion vs Output voltage 24-29
Output impedance vs Frequency 30
Common-mode rejection ratio vs Frequency 31
Input current noise vs Frequency 32
Voltage noise density vs Frequency 33
Power-supply rejection ratio vs Frequency 34
Common-mode rejection ratio (DC) vs Input common-mode range 35
Supply current vs Power-supply voltage 36, 37
Slew rate vs Output voltage 38, 39
Slew rate vs Output step 40
Input offset voltage vs Output voltage swing 41
Overdrive recovery time 42, 43
Differential gain vs Number of 150-Ω loads 44, 45
Differential phase vs Number of 150-Ω loads 46, 47
Copyright © 2002–2009, Texas Instruments Incorporated Submit Documentation Feedback 7
Product Folder Link(s): THS3061 THS3062