Datasheet

Error in Register Capability www.ti.com
Error in Register Capability
Changes in the Document Text
Sheet 17, in the register map for sub-address 0B, change the RW column value
From: RW To: R
Error in Default Value
Changes in the Document Text
Sheet 18, Reg sub-address 08 change register default
From: FE To: BE
CTL3 Not Encoded in Output
The CTL3 input from the device pin or register value is not encoded into the DVI stream. The current
TFP410 is aware of HDCP and encodes the CTL3 signal as 0 in the output. When the device is configured
for manual input with pins 6-8 selected as CTL[3:1], pin 6 is not encoded. When the device is configured
for I2C operation, bit 3 of the CTL_# MODE register at Sub-Address 0A can be written and read, but the
bit is not encoded.
Changes in the Document Text
Sheet 2, change pin 6 label
From: CTL3/A3/DK3 To: A3/DK3
Sheet 4, in the Terminal Functions table, change the name of pin 6
From: CTL3/A3/DK3 To: A3/DK3
Sheet 4, in the Terminal Functions table, change pin 6 Description
From: When the I
2
C bus is disabled (ISEL = low) and the de-skew mode is disabled (DKEN = low),
these three inputs become the control inputs, CTL[3:1], which can be used to send additional
information across the DVI link during the blanking interval (DE = low). The CTL3 input is
reserved for HDCP compliant DVI TXs (TFP510) and the CTL[2:1] inputs are reserved for
future use.
To: When the I
2
C bus is disabled (ISEL = low) and the de-skew mode is disabled (DKEN = low),
pins 7 and 8 become the control inputs, CTL[2:1], which can be used to send additional
information across the DVI link during the blanking interval (DE = low). Pin 6 is not used.
Sheet 10, in the first paragraph of the T.M.D.S. pixel data and control signal encoding section, change
the sentence
From: These same three channels are also used to transmit HSYNC, VSYNC, and three user
definable control signals, CTL[3:1], during the inactive display or blanking interval (DE = Low).
To: These same three channels are also used to transmit HSYNC, VSYNC, and the control signals,
CTL[3:1], during the inactive display or blanking interval (DE = Low).
Errata to TFP410 Datasheet2 SLLZ030A – June 2003 – Revised April 2009
Submit Documentation Feedback