Datasheet

B0396-01
1 – a
rms
ABSCh1
Z
–1
a
Post-DAP Processing
32-BitLevel
I CRegisters
(PWMLevelMeter)
2
rms
ABSCh2
Z
–1
32-BitLevel
ADDR=0x6C
ADDR=0x6B
1 – a
a
2 Bit
–23
S_xx.xxxx_xxxx_xxxx_xxxx_xxxx_xxx
2 Bit
–5
2 Bit
–1
2 Bit
0
SignBit
2 Bit
1
M0125-01
(1or0) 2 +´
1
(1or0) 2 +(1or0) 2 +.......(1or0) 2 +.......(1or0) 2´ ´ ´ ´
0 –1 –4 –23
2 Bit
1
2 Bit
0
2 Bit
–1
2 Bit
–4
2 Bit
–23
M0126-01
TAS5727
SLOS670 –NOVEMBER 2010 www.ti.com
PWM LEVEL METER
The structure in Figure 32 shows the PWM level meter that can be used to study the power profile.
Figure 32. PWM Level Meter Structure
26-Bit 3.23 Number Format
All mixer gain coefficients are 26-bit coefficients using a 3.23 number format. Numbers formatted as 3.23
numbers means that there are 3 bits to the left of the binary point and 23 bits to the right of the binary point. This
is shown in Figure 33 .
Figure 33. 3.23 Format
The decimal value of a 3.23 format number can be found by following the weighting shown in Figure 33. If the
most significant bit is logic 0, the number is a positive number, and the weighting shown yields the correct
number. If the most significant bit is a logic 1, then the number is a negative number. In this case every bit must
be inverted, a 1 added to the result, and then the weighting shown in Figure 34 applied to obtain the magnitude
of the negative number.
Figure 34. Conversion Weighting Factors—3.23 Format to Floating Point
28 Submit Documentation Feedback Copyright © 2010, Texas Instruments Incorporated
Product Folder Link(s): TAS5727