Datasheet

Using the GUI www.ti.com
Table 1. ControlConsole Process Flow Icons
Name Symbol Function Interaction
Implement IIR filters
in the DAP by using • Open the Biquad GUI by double
the biquad filters. clicking
Biquad
They are often used
• Open the Biquad GUI or the biquad-
for speaker
specific help page by right clicking
equalization.
Each mixer adds
two or more signals
• Click the dial and drag up, increasing
together. The dials
volume; drag down, decreasing
Mixer allow for the user to
volume.
adjust the scalar
Note: this is a vertical movement,
multiplier for each
not circular
input signal.
Clicking the MUX
changes the active
• Click to change the pass-through
Mux path. This allows the
path. The active path is black,
creation of a variety
inactive paths are grayed out
of process flows.
• Single click turns on and off
• Right click options:
The DRC tool allows
Dynamic Range for adjustments to
– Turns on or off
Control (DRC) the dynamic range
– Opens DRC GUI
of the signal.
– Opens DRC-specific help
page
Several volume
ganging sets are
available. When a
• Clicking and dragging the slider
particular ganging
adjusts the volume
setting is applied,
• Type a volume in the text box below
Volume Ganging the matched volume
the slider (where 0 currently is)
sliders are color
• Right clicking opens the Volume
coded. Moving one
Ganging menu
slider will move all
sliders of the same
color.
The master volume
• Clicking and dragging the slider
is a simple way to
adjusts the volume
adjust the final
• Type a volume in the text box below
volume of the
the slider (where 8 currently is)
Master Volume output. The pre- and
• Clicking the speaker symbol mutes
post-output volume
and unmutes the device
sliders also adjust
the final volume of
• Right clicking mutes and unmutes
the audio signal.
the device
8
TAS5721-TAS5723EVM Evaluation Module SLOU346–July 2012
Copyright © 2012, Texas Instruments Incorporated