Datasheet

Installation

www.ti.com

NOTE: Minimize the length of the PSU cable. Increasing the length of the PSU cable increases the

distortion of the amplifier at high output levels and low frequencies.

2.1.3 Loudspeaker Connectors

CAUTION

All BTL speaker outputs are biased at Vcc/2 and must not be connected to

ground (e.g., through an oscilloscope ground).

2.1.3.1 BTL Mode (2.0)

When connecting a speaker in BTL mode, connect one speaker across the connector labeled LEFT and

the other speaker to the connector labeled RIGHT.

Figure 2. BTL Configuration

TAS5721-TAS5723EVM Evaluation Module SLOU346–July 2012