Datasheet

TAS5717
TAS5719
www.ti.com
SLOS655A NOVEMBER 2010REVISED FEBRUARY 2011
SYSTEM CONTROL REGISTER 2 (0x05)
When bit D6 is set low, the system exits all-channel shutdown and starts playing audio; otherwise, the outputs
are shut down (hard mute).
Table 9. System Control Register 2 (0x05)
D7 D6 D5 D4 D3 D2 D1 D0 FUNCTION
0 Reserved
(1)
0 Exit all-channel shutdown (normal operation)
(2)
1 Enter all-channel shutdown (hard mute)
(1)
0 - - Reserved
(1)
1 Headphone Mode
0 Speaker Mode
1. In speaker mode, a value of 1 means device is in ternary modulation.
1 2. In headphone mode, a value of 1 means channel volume in headphone mode =
0x08/0x09 (same as speaker channel volume).
1. In speaker mode, a value of 0 means device is in not in ternary modulation (AD
or BD as defined in register 0x25).
0
2. In headphone mode, 0 means channel volume in headphone mode = 0x0C
(headphone volume register).
(1)
0 Reserved
(1)
0 A_SEL/HP_SD configured as input
A_SEL/HP_SD configured configured as output to use as external HP amplifier
1
shutdown signal
0 Internal power stage FAULT signal is the source of A_SEL/HP_SD pin
HPSDZ is the source of A_SEL/HP_SD pin (set this before switching to headphone
1
mode)
(1) Default values are in bold.
(2) When exiting all-channel shutdown, soft unmute is might not occur unless register 0x03, bit 5 is set to 1.
SOFT MUTE REGISTER (0x06)
Writing a 1 to any of the following bits sets the output of the respective channel to 50% duty cycle (soft mute).
Table 10. Soft Mute Register (0x06)
D7 D6 D5 D4 D3 D2 D1 D0 FUNCTION
0 0 0 0 0 Reserved
(1)
1 Soft mute channel 3
0 Soft unmute channel 3
(1)
1 Soft mute channel 2
0 Soft unmute channel 2
(1)
1 Soft mute channel 1
0 Soft unmute channel 1
(1)
(1) Default values are in bold.
© 20102011, Texas Instruments Incorporated Submit Documentation Feedback 41
Product Folder Link(s): TAS5717 TAS5719