Datasheet

Analog In to ADC
Coaxial SPDIF Input
Optical SPDIF Input
USB Port
5V Supply for
System Power
4.5V–26V Supply for Output Power
Headphone
Out
Speaker
Out C & D
Speaker
Out A & B
Headphone
In
Installation www.ti.com
2 Installation
This section describes the EVM and software installation.
2.1 EVM Installation
Figure 4. General Connection Picture
The following are the basic tools for the initial EVM power up.
• 5V, 1A power supply (VIN)
• 4.5–26V, 4A power supply (PVDD)
• Banana-plug test leads for power supplies and speakers
• Optical or coaxial cable for SPDIF interface based on signal source
• USB cable
• EVM software
• Two 8Ω speakers or loads
The following sections describe the TAS5717/19EVM board in regards to power supply (PSU) and system
interfaces.
2.1.1 Connecting the TAS5717/19EVM to MC57xxPSIA
On the right side of the MC57xxPSIA is a terminal block and another on the left of the TAS5717/19EVM
(labeled J1). Carefully place the MC57xxPSIA block above the TAS5717/19EVM block and gently push
down.
Figure 5. Connecting TAS5717/19EVM to MC57xxPSIA
4
TAS5717/19 10W/15W Digital Audio Power Amplifier with Integrated SLOU303–November 2010
Capacitor-Free HP Amplifier
Submit Documentation Feedback
Copyright © 2010, Texas Instruments Incorporated