Datasheet

RESET TIMING ( RESET)
t
w(RESET)
RESET
t
d(I2C_ready)
SystemInitialization.
EnableviaI C.
2
T0421-01
I C Active
2
I C Active
2
TYPICAL CHARACTERISTICS, BTL CONFIGURATION
f − Frequency − Hz
20
PVCC = 12 V
R
L
= 8 Ω
100 1k 10k
THD+N − Total Harmonic Distortion + Noise − %
20k
G001
0.001
0.01
10
0.1
1
P
O
= 4 W
P
O
= 0.5 W
P
O
= 2 W
f − Frequency − Hz
20
PVCC = 18 V
R
L
= 8 Ω
100 1k 10k
THD+N − Total Harmonic Distortion + Noise − %
20k
G002
0.001
0.01
10
0.1
1
P
O
= 10 W
P
O
= 1 W
P
O
= 5 W
TAS5710
SLOS605 – JANUARY 2009 ............................................................................................................................................................................................... www.ti.com
Control signal parameters over recommended operating conditions (unless otherwise noted). Please refer to Recommended
Use Model section on usage of all terminals.
PARAMETER MIN TYP MAX UNIT
t
w(RESET)
Pulse duration, RESET active 100 us
t
d(I2C_ready)
Time to enable I
2
C 13.5 ms
NOTE: On power up, it is recommended that the TAS5710 RESET be held LOW for at least 100 µ s after DVDD has reached
3.0 V
NOTE: If the RESET is asserted LOW while PDN is LOW, then the RESET must continue to be held LOW for at least 100 µ s
after PDN is deasserted (HIGH).
Figure 6. Reset Timing
TOTAL HARMONIC DISTORTION + NOISE TOTAL HARMONIC DISTORTION + NOISE
vs vs
FREQUENCY FREQUENCY
Figure 7. Figure 8.
12 Submit Documentation Feedback Copyright © 2009, Texas Instruments Incorporated
Product Folder Link(s): TAS5710