Datasheet

2 Installation
2.1 EVM Installation
AnalogInto ADC
CoaxialSPDIFInput
OpticalSPDIFInput
USBPort
5VSupplyfor
SystemPower
10V–26 VSupplyforOutputPower
Speaker
Out A &B
Speaker
OutC&D
MC57xxPSIA
ControllerBoard
2.1.1 Connecting the TAS5708(TAS5710)EVM to MC57xxPSIA
Installation www.ti.com
This section describes the EVM and software installation.
Figure 3. General Connection Picture
The following are the basic tools for the initial EVM power up.
• 5-V, 1-A power supply (VIN)
• 10–26-V, 4-A power supply (PVCC)
• Banana-style test leads for power supplies and speakers
• Optical or coaxial cable for SPDIF interface based on signal source
• USB cable
• EVM software
• Two 8- Ω speakers or loads
The following sections describe the TAS5708(TAS5710)EVM board in regards to power supply (PSU) and
system interfaces.
On the right side of the MC57xxPSIA is a terminal block and another on the left of the
TAS5708(TAS5710)EVM (labeled J1). Carefully place the MC57xxPSIA block above the EVM, and gently
push down.
4 TAS5708(TAS5710)EVM SLOU232A – January 2009 – Revised January 2009
Submit Documentation Feedback