Datasheet

2.1.2 PSU Interface
www.ti.com Installation
Figure 4. Connecting TAS5708(TAS5710)EVM to MC57xxPSIA
The TAS5708(TAS5710)EVM is powered by two power supplies connected to the MC57xx controller
board: a 5-V power supply (VIN) and a 10-V to 26-V (PVCC) power supply. The 3.3-V level is generated
on the board by a voltage regulator from the 5-V supply.
Note: The power-supply cable length must be minimized. Increasing the length of the PSU cable
increases the distortion of the amplifier at high output levels and low frequencies
The maximum output-stage supply voltage depends on the speaker load resistance. Check the
recommended maximum supply voltage in the TAS5708/10 (SLOS570 ) data sheet.
Table 1. Recommended Power Supplies
Description Voltage Limitations (8- Ω Load) Current Recommendations
System power supply 5 V 1 A
Output power stage supply 10–26 V 4 A
(1)
(1)
The rated current corresponds to two channels, full scale.
SLOU232A – January 2009 – Revised January 2009 TAS5708(TAS5710)EVM 5
Submit Documentation Feedback