Datasheet

2 Installation
2.1 EVM Installation
AnalogInto ADC
CoaxialSPDIFInput
OpticalSPDIFInput
USBPort
5VSupplyfor
SystemPower
8-24VSupplyforOutputPower
Speaker
Out A &B
Speaker
OutC&D
TAS5705EVM2&MC-57xxPSIA
GeneralConnectionPicture
TAS5706EVM2
2.1.1 Connecting the TAS5705EVM2 to MC57xxPSIA
www.ti.com
Installation
This section describes the EVM and software installation.
Figure 3. General Connection Picture
The following are the basic tools for the initial EVM power up.
5-V, 1-A power supply (VIN)
8–24-V, 4-A power supply (PVCC)
Banana-style test leads for power supplies and speakers
Optical or coaxial cable for SPDIF interface based on signal source
USB cable
EVM software
Two 8- speakers or loads
The following sections describe the TAS5705EVM2 board in regards to power supply (PSU) and system
interfaces.
On the right side of the MC57xxPSIA is a terminal block and another on the left of the TAS5705EVM2
(labeled J1). Carefully place the MC57xxPSIA block above the TAS5705EVM2 block and gently push
down.
SLOU223A December 2008 Revised January 2009 TAS5705EVM2 : STEREO DIGITAL INPUT AMPLIFIER WITH EQ and DRC 5
Submit Documentation Feedback