Datasheet

www.ti.com
2.2 Unpacking the EVM
Quick Setup Guide
Upon opening the TAS5176DDW6EVM package, check to make sure that the following items are
included:
• 1 TAS5176DDW6EVM board using one TAS5086DBT and one TAS5176DDW
• 1 TI input-USB board for interfacing TAS5176DDW6EVM with SPDIF/analog sources and PC for
control
• 1 Signal interface IDC cable for connection to an I
2
S front-end like the attached TI Input-USB board
• 1 Control interface IDC cable for connection to an I
2
C front-end like the attached TI Input-USB board
• 1 Cable for connecting input-USB board to a USB port on a PC for TAS5086 control by software
• 1 Power supply cable for two regulated power supplies (H-bridge and system supply)
• 1 PurePath CD-ROM
If any of these items is missing, contact the Texas Instruments Product Information Center nearest you to
inquire about a replacement.
Connect the input-USB board to the TAS5176DDW6EVM using the two delivered IDC cables.
TAS5176DDW6EVM 6 SLOU209A – September 2007 – Revised October 2007
Submit Documentation Feedback