Datasheet
www.ti.com
2.4 Speaker Connection
2.5 GUI Software Installation
Quick Setup Guide
Note: The length of power supply cable must be minimized. Increasing length of PSU
cable is equal to increasing the distortion for the amplifier at high output levels and
low frequencies.
CAUTION
Both positive and negative speaker outputs are floating and may not be
connected to ground (e.g. through an oscilloscope).
The TAS5518 GUI provides easy control of all registers in the TAS5518. To install the GUI, run setup file
from the PurePathâ„¢ CD-ROM.
After installation, turn on the power supplies and connect the USB cable to the Input-USB board.
Start GUI program from windows menu. Start up of GUI will take few seconds.
Figure 3. TAS5518 GUI Window
6 TAS5162DKD6EVM SLAU223 – June 2007
Submit Documentation Feedback