Datasheet

www.ti.com
2.5 GUI Software Installation
3 Protection
Protection
The TAS5086 GUI provides easy control of all registers in TAS5086. To install the GUI, run the setup file
from the PurePath CD-ROM.
After installation, turn on the power supplies and connect the USB cable to the Input-USB board.
Start the GUI program from Windows™ menu. Start-up of the GUI takes a few seconds.
Figure 3. TAS5086 GUI Window
From the files menu, load the configuration file:
TAS5132DDV6EVM Configuration (2.00).cfg
The file is located on the PurePath CD-ROM. This file contains all settings for a default setup of the EVM.
For easy access of the file, it is recommended to copy the files into a directory where the GUI is installed.
Default is C:\Program Files\Texas Instruments Inc\TAS5086\
For more advanced use of the GUI, see the GUI User’s Guide and the TAS5086 data sheet (SLES131 ).
This section describes the short-circuit protection and fault-reporting circuitry of the TAS5132 device.
6 TAS5132DDV6EVM SLLU096A – February 2007 – Revised March 2007
Submit Documentation Feedback