Datasheet

SRC4392

www.ti.com

SBFS029D –DECEMBER 2005–REVISED DECEMBER 2012

Bit 7 (MSB) Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 (LSB)

SRF7 SRF6 SRF5 SRF4 SRF3 SRF2 SRF1 SRF0

SRI[4:0] Integer Part of the Input-to-Output Sampling Ratio

SRF[10:0] Fractional Part of the Input-to-Output Sampling Ratio

In order to properly read back the ratio, these registers must be read back in sequence, starting

with register 0x32.

Bit 7 (MSB) Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 (LSB)

0 0 0 0 0 0 PAGE1 PAGE0

PAGE[1:0] Page Selection

These bits are utilized to select one of three register pages for write and/or read access via the

SPI or I

C serial host interface. The Page Selection Register is present on every register page at

address 0x7F, allowing movement between pages as necessary.

PAGE1 PAGE0 Register/Buffer Page Selection

0 0 Page 0, Control and Status Registers (Default)

0 1 Page 1, DIR Channel Status and User Data Buffers

1 0 Page 2, DIT Channel Status and User Data Buffers

1 1 Page 3, Reserved

CHANNEL STATUS AND USER DATA BUFFER MAPS

Table 5 through Table 8 show the buffer maps for the DIR and DIT channel status and user data buffers.

For Table 5, the channel status byte definitions are dependent on the transmission mode, either Professional or

Consumer. Bit 0 of Byte 0 defines the transmission mode, 0 for Consumer mode, and 1 for Professional mode.

This is applicable for Table 5 and Table 6.

For Table 7, the channel status byte definitions are dependent on the transmission mode, either Professional or

Consumer. Bit 0 of Byte 0 defines the transmission mode, 0 for Consumer mode, and 1 for Professional mode. In

Professional mode, Byte 23 for each channel is reserved for CRC data, which is automatically calculated and

encoded by the DIT. There is no need to program Byte 23 for either channel in Professional mode.

Product Folder Links: SRC4392