Datasheet
SRC4392
SBFS029D –DECEMBER 2005–REVISED DECEMBER 2012
www.ti.com
Register 11: Receiver PLL1 Configuration Register 3
Bit 7 (MSB) Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 (LSB)
D7 D6 D5 D4 D3 D2 D1 D0
Registers 0x0F through 0x11 are utilized to program PLL1 in the DIR core. PLL1 multiplies the DIR reference
clock source to an oversampling rate which is adequate for AES3 decoder operation. PLL1 is programmed
using the following relationship:
(CLOCK × K) / P = 98.304MHz
where:
CLOCK = frequency of the DIR reference clock source.
K = J.D, where the integer part J = 1 to 63, and the fractional part D = 0 to 9999.
P = the pre-divider value, which may be set to any 4-bit value that meets the conditions stated below.
The following conditions must be met for the values of P, J, and D:
If D = 0, then: If D ≠ 0, then:
2 MHz ≤ (CLOCK / P) ≤ 20 MHz and 4 ≤ J 10 MHz ≤ (CLOCK / P) ≤ 20 MHz and 4 ≤ J
≤ 55. ≤11.
Referring to registers 0x0F through 0x11:
P is programmed using bits P[3:0].
J is programmed using bits J[5:0].
D is programmed using bits D[13:0].
Table 4 shows values for P, J, and D for common DIR reference clock rates.
Table 4. PLL1 Register Values for Common Reference Clock Rates
REFERENCE CLOCK RATE (MHz) P J D ERROR (%)
8.1920 1 12 0 0.0000
11.2896 1 8 7075 0.0002
12.2880 1 8 0 0.0000
16.3840 1 6 0 0.0000
22.5792 2 8 7075 0.0002
24.5760 2 8 0 0.0000
27.0000 2 7 2818 0.0003
Register 12: Non-PCM Audio Detection Status Register (Read-Only)
Bit 7 (MSB) Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 (LSB)
0 0 0 0 0 0 DTS CD/LD IEC61937
IEC61937 This bit is utilized to indicate the detection of an IEC 61937 data reduced audio format (includes
Dolby AC-3, DTS, etc.) for DVD playback or general transmission purposes.
IEC61937 Status
0 Data is not an IEC61937 format.
Data is an IEC61937 format. Refer to the PC and PD preamble
1 registers (addresses 0x29 through 0x2C) for data type and
burst length.
DTS CD/LD This bit is used to indicate the detection of a DTS encoded audio compact disc (CD) or
Laserdisc (LD) playback.
DTS CD/LD Status
0 The CD/LD is not DTS encoded.
1 DTS CD/LD playback detected.
64 Submit Documentation Feedback Copyright © 2005–2012, Texas Instruments Incorporated
Product Folder Links: SRC4392