Datasheet

Default Configuration
2-3
Getting Started
2.4 Default Configuration
The factory default switch and jumper settings are shown in Table 2, and result
in the following EVM configuration:
- The SRC4192 Input Port is set to Slave mode, with the CS8414 receiver
selected as the input source.
- The SRC4192 Output Port is set to Slave mode, with the DIT4192 trans-
mitter selected as the output device.
- The SRC PLL (U16) is selected as the SRC419x reference clock source
and is set to 24.576MHz.
- The SRC4192 input and output port data formats are set to 24–Bit Left
Justified.
- The CS8414 receiver output format is set to 24–Bit Left Justified
- The DIT4192 transmitter input format is set to 24–Bit Left Justified
- The DIT4192 transmitter MCLK frequency is set to 256fs, with fs = 48kHz.
- The transmitter PLL (U6) is selected as the DIT4192 MCLK source and is
set to 12.288MHz.
- The DIT4192 transmitter output mode is set to stereo.
- The SRC4192 Low Group Delay, Bypass, and Mute modes are all dis-
abled.
Table 2–2.Default Switch and Jumper Settings
SW1 Set To: SW3 Set To: SW6 Set To: SW7 Set To:
M0
M1
M2
LO
LO
LO
CLK1
CLK0
FMT0
FMT1
LO
HI
LO
LO
TSR
TFS2
TFS1
TPLL
LO
LO
LO
LO
LGRP
BYPAS
IFMT0
IFMT1
IFMT2
MUTE
~4193
IS/M
LO
LO
LO
LO
LO
LO
HI
HI
SW9 Set To: SW10 Set To: J8 Set To:
SFS1
SFS2
SSR
~PLL
OM/~S
~IPORT
MONO
MDAT
LO
LO
HI
LO
LO
HI
LO
LO
MODE2
MODE1
MODE0
~PORT
OFMT0
OFMT1
OWL0
OWL1
LO
LO
LO
HI
LO
LO
LO
LO
1–2 (I2S/RJ)
3–4 (LJ)
OPEN
SHORT