Datasheet

www.ti.com
1OE
1CLK
1D1
To Seven Other Channels
1Q1
2OE
2CLK
2D1
2Q1
To Seven Other Channels
1
48
47
24
25
36
C1
1D
132
C1
1D
Pin numbers shown are for the DGG, DL, and WD packages.
Absolute Maximum Ratings
(1)
Recommended Operating Conditions
(1)
SN54LVTH162374 , , SN74LVTH162374
3.3-V ABT 16-BIT EDGE-TRIGGERED D-TYPE FLIP-FLOPS
WITH 3-STATE OUTPUTS
SCBS262M – JULY 1993 – REVISED NOVEMBER 2006
LOGIC DIAGRAM (POSITIVE LOGIC)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range –0.5 4.6 V
V
I
Input voltage range
(2)
–0.5 7 V
V
O
Voltage range applied to any output in the high-impedance or power-off state
(2)
–0.5 7 V
V
O
Voltage range applied to any output in the high state
(2)
–0.5 V
CC
+ 0.5 V
I
O
Current into any output in the low state 30 mA
I
O
Current into any output in the high state
(3)
30 mA
I
IK
Input clamp current V
I
< 0 –50 mA
I
OK
Output clamp current V
O
< 0 –50 mA
DGG package 70
DL package 63
θ
JA
Package thermal impedance
(4)
° C/W
GQL/ZQL package 42
GRD/ZRD package 36
T
stg
Storage temperature range –65 150 ° C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(3) This current flows only when the output is in the high state and V
O
> V
CC
.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
SN54LVTH162374 SN74LVTH162374
UNIT
MIN MAX MIN MAX
V
CC
Supply voltage 2.7 3.6 2.7 3.6 V
V
IH
High-level input voltage 2 2 V
V
IL
Low-level input voltage 0.8 0.8 V
V
I
Input voltage 5.5 5.5 V
I
OH
High-level output current –12 –12 mA
I
OL
Low-level output current 12 12 mA
∆ t/ ∆ v Input transition rise or fall rate Outputs enabled 10 10 ns/V
∆ t/ ∆ V
CC
Power-up ramp rate 200 200 µ s/V
T
A
Operating free-air temperature –55 125 –40 85 ° C
(1) All unused control inputs of the device must be held at V
CC
or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
4
Submit Documentation Feedback