Datasheet

www.ti.com
1B
1C
1A
1
7
2
One of Two Switches
Absolute Maximum Ratings
(1)
SN74LVC2G66
DUAL BILATERAL ANALOG SWITCH
SCES325J – JULY 2001 – REVISED FEBRUARY 2007
FUNCTION TABLE
(EACH SECTION)
CONTROL
INPUT SWITCH
(C)
L Off
H On
LOGIC DIAGRAM, EACH SWITCH (POSITIVE LOGIC)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range
(2)
–0.5 6.5 V
V
I
Input voltage range
(2) (3)
–0.5 6.5 V
V
O
Switch I/O voltage range
(2) (3) (4)
–0.5 V
CC
+ 0.5 V
I
IK
Control input clamp current V
I
< 0 –50 mA
I
I/OK
I/O port diode current V
I/O
< 0 or V
I/O
> V
CC
–50 mA
I
T
On-state switch current V
I/O
= 0 to V
CC
± 50 mA
Continuous current through V
CC
or GND ± 100 mA
DCT package 220
θ
JA
Package thermal impedance
(5)
DCU package 227 °C/W
YZP package 102
T
stg
Storage temperature range –65 150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltages are with respect to ground, unless otherwise specified.
(3) The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
(4) This value is limited to 5.5 V maximum.
(5) The package thermal impedance is calculated in accordance with JESD 51-7.
2
Submit Documentation Feedback