Datasheet
www.ti.com
Absolute Maximum Ratings
(1)
Recommended Operating Conditions
(1)
SN74LVC1G06-EP
SINGLE INVERTER BUFFER/DRIVER
WITH OPEN-DRAIN OUTPUT
SCES669A – JULY 2006 – REVISED MARCH 2007
ORDERING INFORMATION
(1)
T
A
PACKAGE
(2)
ORDERABLE PART NUMBER TOP-SIDE MARKING
(3)
–55 ° C to 125 ° C SOT (SC-70) – DCK Reel of 3000 SN74LVC1G06MDCKREP
(4)
CBA
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
Web site at www.ti.com .
(2) Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at
www.ti.com/sc/package.
(3) The actual top-side marking has one additional character that designates the assembly/test site.
(4) Product Preview
FUNCTION TABLE
INPUT OUTPUT
A Y
H L
L H
LOGIC DIAGRAM (POSITIVE LOGIC)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range –0.5 6.5 V
V
I
Input voltage range
(2)
–0.5 6.5 V
V
O
Voltage range applied to any output in the high-impedance or power-off state
(2)
–0.5 6.5 V
V
O
Voltage range applied to any output in the high or low state
(2) (3)
–0.5 6.5 V
I
IK
Input clamp current V
I
< 0 V –50 mA
I
OK
Output clamp current V
O
< 0 V –50 mA
I
O
Continuous output current ± 50 mA
Continuous current through V
CC
or GND ± 100 mA
θ
JA
Package thermal impedance
(4)
252 ° C/W
T
stg
Storage temperature range –65 150 ° C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input and output negative-voltage ratings may be exceeded if the input and output current ratings are observed.
(3) The value of V
CC
is provided in the recommended operating conditions table.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
MIN MAX UNIT
Operating 1.65 5.5
V
CC
Supply voltage V
Data retention only 1.5
V
CC
= 1.65 V to 1.95 V 0.65 × V
CC
V
CC
= 2.3 V to 2.7 V 1.7
V
IH
High-level input voltage V
V
CC
= 3 V to 3.6 V 2
V
CC
= 4.5 V to 5.5 V 0.7 × V
CC
(1) All unused inputs of the device must be held at V
CC
or GND to ensure proper device operation. See the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
2
Submit Documentation Feedback