Datasheet
SN74LV541AT
www.ti.com
SCES573B –JUNE 2004–REVISED JULY 2013
ABSOLUTE MAXIMUM RATINGS
(1)
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range –0.5 7 V
V
I
Input voltage range
(2)
–0.5 7 V
V
O
Voltage range applied to any output in the high-impedance or power-off state
(2)
–0.5 7 V
V
O
Output voltage range applied in the high or low state
(2)(3)
–0.5 V
CC
+ 0.5 V
I
IK
Input clamp current V
I
< 0 –20 mA
I
OK
Output clamp current V
O
< 0 –50 mA
I
O
Continuous output current V
O
= 0 to V
CC
±35 mA
Continuous current through V
CC
or GND ±70 mA
DB package
(4)
70
DGV package
(4)
92
DW package
(4)
58
θ
JA
Package thermal impedance °C/W
NS package
(4)
60
PW package
(4)
83
RGY package
(5)
37
T
stg
Storage temperature range –65 150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input and output negative-voltage ratings may be exceeded if the input and output current ratings are observed.
(3) This value is limited to 5.5 V maximum.
(4) The package thermal impedance is calculated in accordance with JESD 51-7
(5) The package thermal impedance is calculated in accordance with JESD 51-5.
RECOMMENDED OPERATING CONDITIONS
(1)
MIN MAX UNIT
V
CC
Supply voltage 4.5 5.5 V
V
IH
High-level input voltage V
CC
= 4.5 V to 5.5 V 2 V
V
IL
Low-level input voltage V
CC
= 4.5 V to 5.5 V 0.8 V
V
I
Input voltage 0 5.5 V
High or low state 0 V
CC
V
O
Output voltage V
3-state 0 5.5
I
OH
High-level output current V
CC
= 4.5 V to 5.5 V –16 mA
I
OL
Low-level output current V
CC
= 4.5 V to 5.5 V 16 mA
Δt/Δv Input transition rise or fall rate V
CC
= 4.5 V to 5.5 V 20 ns/V
T
A
Operating free-air temperature –40 125 °C
(1) All unused inputs of the device must be held at V
CC
or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
Copyright © 2004–2013, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Links: SN74LV541AT