Datasheet
www.ti.com
Absolute Maximum Ratings
(1)
Recommended Operating Conditions
(1)
SN74HC4852-Q1
DUAL 4-TO-1 CHANNEL ANALOG MULTIPLEXER/DEMULTIPLEXER
WITH INJECTION-CURRENT EFFECT CONTROL
SCLS705A – DECEMBER 2006 – REVISED FEBRUARY 2008
over operating free-air temperature range (unless otherwise noted)
MIN MAX UNIT
V
CC
Supply voltage range – 0.5 7 V
V
I
Input voltage range
(2)
– 0.5 V
CC
+ 0.5 V
V
IO
Switch I/O voltage range
(2) (3)
– 0.5 V
CC
+ 0.5 V
I
IK
Input clamp current V
I
< 0 or V
I
> V
CC
± 20 mA
I
IOK
I/O diode current V
IO
< 0 or V
IO
> V
CC
± 20 mA
I
S
Switch through current V
IO
= 0 to V
CC
± 25 mA
Continuous current through V
CC
or GND ± 50 mA
D package 73
θ
JA
Package thermal impedance
(4)
° C/W
PW package 108
T
stg
Storage temperature range – 65 150 ° C
Human-Body Model (HBM) 2000
ESD Electrostatic discharge protection Machine Model (MM) 200 V
Charged-Device Model (CDM) 1000
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input and output voltage ratings may be exceeded if the input and output current ratings are observed.
(3) This value is limited to 5.5 V maximum.
(4) The package thermal impendance is calculated in accordance with JESD 51-7.
MIN MAX UNIT
V
CC
Supply voltage 2 6 V
V
CC
= 2 V 1.5
V
CC
= 3 V 2.1
V
IH
High-level input voltage, control inputs V
CC
= 3.3 V 2.3 V
V
CC
= 4.5 V 3.15
V
CC
= 6 V 4.2
V
CC
= 2 V 0.5
V
CC
= 3 V 0.9
V
IL
Low-level input voltage, control inputs V
CC
= 3.3 V 1 V
V
CC
= 4.5 V 1.35
V
CC
= 6 V 1.8
V
I
Control input voltage 0 V
CC
V
V
IO
Input/output voltage 0 V
CC
V
V
CC
= 2 V 1000
V
CC
= 3 V 800
Δ t/ Δ v Input transition rise or fall rate V
CC
= 3.3 V 700 ns
V
CC
= 4.5 V 500
V
CC
= 6 V 400
T
A
Operating free-air temperature – 40 125 ° C
(1) All unused inputs of the device must be held at V
CC
or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
Copyright © 2006 – 2008, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Link(s): SN74HC4852-Q1