Datasheet

Enable
Input x
Output x
11
SN54HC32 , SN74HC32
www.ti.com SCLS200E –DECEMBER 1982–REVISED JULY 2016
Product Folder Links: SN54HC32 SN74HC32
Submit Documentation FeedbackCopyright © 1982–2016, Texas Instruments Incorporated
Typical Application (continued)
– If input voltages ratings must be exceeded, ensure that the maximum input current ratings are not
exceeded.
– Ensure that the input signals have edge rates that are equal to or faster than that listed in Recommended
Operating Conditions. Slower signals can cause incorrect behavior and possibly damage to the part.
• Each output must also follow requirements in Absolute Maximum Ratings:
– Avoid bus contention by only connecting outputs together when inputs are tied together directly.
– Avoid forcing output voltages outside those specified in Absolute Maximum Ratings.
– If output voltage ratings must be exceeded, ensure that the maximum output current ratings are not
exceeded.
– Ensure that the total current output does not exceed the continuous current through V
CC
or GND listed in
Absolute Maximum Ratings.
9.2.3 Application Curves
Dotted lines indicate Enable signal changes
Figure 7. Application Timing Diagram