Datasheet

Measurements
7–353 Oscilloscope Operation
To adjust the timing (x or horizontal axis), press the appropriate side of the
SEC/DIV button (see Figure 3–6). An example of the results is shown for
50 ns/division and 100 ns/division. Timing is the same for both channels and
is independent of channel selection.
Figure 3–6. Timing Adjustment
To adjust the voltage (y or vertical axis), press the top or bottom of the
VOLTS/DIV button (see Figure 3–7). An example of the results is shown for
Ch2 at 1 V (center) and Ch2 at 2 V (right). Voltage adjustment is independent
of channels, which are selected by pressing either the CH 1 or the CH 2 button.
Figure 3–7. Voltage Adjustment