Datasheet

Measurements
7–351
Oscilloscope Operation
3.2 Measurements
The first step in taking measurements is to plug one probe into channel 1
(CH 1) of the O-Scope and connect the opposite end to the desired monitor
point. Plug the other probe into channel 2 (CH 2) of the O-Scope and connect
the opposite end to the desired monitor point (see Figures 3–1 and 3–3).
Chapter 4,
Waveform Measurement and Interpretation
, discusses which
monitor points should be used and why.
Figure 3–3. Simple Test-Measurement Connection
Press the ON/STBY button on the O-Scope (see Figure 3–4), and press the
CH 1 or CH 2 button.
Figure 3–4. Turn On O-Scope (Left) and Select Channel (Right)