Datasheet

Backplane Setup
7–346
Figure 2–30. Close-up View of Connector Keying
Wide Key
Narrow Key
The card should be placed squarely on the connector and pressed down (see
Figure 2–31), with very little side-to-side motion. The components are facing
left towards slot 1, the power supplies are on the top/right, and the Group 1–6
markings are on the bottom/left. The card in Figure 2–31 is being inserted into
slot 20.
Figure 2–31. Proper Connector Mating Sequence (Left to Right)
Figure 2–32 shows the connectors properly mated.