Datasheet

SN54GTL16612, SN74GTL16612
18-BIT LVTTL-TO-GTL/GTL+ UNIVERSAL BUS TRANSCEIVERS
SCBS480K – JUNE 1994 – REVISED AUGUST 2001
2–16
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
description (continued)
Data flow in each direction is controlled by output-enable (OEAB and OEBA), latch-enable(LEAB and LEBA),
and clock (CLKAB and CLKBA) inputs. The clock can be controlled by the clock-enable (CEAB and CEBA)
inputs. For A-to-B data flow, the devices operate in the transparent mode when LEAB is high. When LEAB is
low, the A data is latched if CEAB
is low and CLKAB is held at a high or low logic level. If LEAB is low, the A data
is stored in the latch/flip-flop on the low-to-high transition of CLKAB if CEAB also is low. When OEAB is low, the
outputs are active. When OEAB is high, the outputs are in the high-impedance state. Data flow for B to A is
similar to that for A to B, but uses OEBA, LEBA, CLKBA, and CEBA.
These devices are fully specified for partial-power-down applications using I
off
. The I
off
circuitry disables the
outputs, preventing damaging current backflow through the device when it is powered down.
Active bus-hold circuitry holds unused or undriven LVTTL inputs at a valid logic state. Use of pullup or pulldown
resistors with the bus-hold circuitry is not recommended.
ORDERING INFORMATION
T
A
PACKAGE
†
ORDERABLE
PART NUMBER
TOP-SIDE
MARKING
SSOP DL
Tube SN74GTL16612DL
GTL16612
–40°C to 85°C
SSOP
–
DL
Tape and reel SN74GTL16612DLR
GTL16612
TSSOP – DGG Tape and reel SN74GTL16612DGGR GTL16612
–55°C to 125°C CFP – WD Tube SNJ54GTL16612WD SNJ54GTL16612WD
†
Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are
available at www.ti.com/sc/package.
FUNCTION TABLE
‡
INPUTS
OUTPUT
MODE
CEAB OEAB LEAB CLKAB A
B
MODE
X H X X X Z Isolation
L L L H X B
0
§
Latched storage of A data
L LL LXB
0
¶
Latched
storage
of
A
data
X L H X L L
Trans
p
arent
X LH X H H
Transparent
L L L ↑ L L
Clocked storage of A data
L LL ↑ HH
Clocked
storage
of
A
data
H L L X X B
0
¶
Clock inhibit
‡
A-to-B data flow is shown. B-to-A data flow is similar but uses OEBA, LEBA, CLKBA,
and CEBA
.
§
Output level before the indicated steady-state input conditions were established, provided
that CLKAB was high before LEAB went low
¶
Output level before the indicated steady-state input conditions were established