Datasheet
SN65MLVD200, SN65MLVD202
SN65MLVD204, SN65MLVD205
MULTIPOINT–LVDS LINE DRIVERS AND RECEIVERS
SLLS463E – SEPTEMBER 2001 – REVISED JUNE 2003
5
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
device electrical characteristics over recommended operating conditions (unless otherwise
noted)
PARAMETER TEST CONDITIONS MIN
†
TYP
‡
MAX UNIT
Receiver disabled and driver enabled
RE and DE at V
CC
,
R
L
= 50 Ω, All others open
13 22
Driver and receiver disabled
RE at V
CC
, DE at 0 V,
R
L
= No load, All others open
1 7
I
CC
Supply current
Receiver enabled and driver enabled
RE at 0 V, DE at V
CC
,
R
L
= 50 Ω, All others open,
No receiver load
16 26
mA
Receiver enabled and driver disabled
RE at 0 V, DE at 0 V,
All others open, No receiver load
4 11
†
The algebraic convention, in which the least positive (most negative) limit is designated as minimum, is used in this data sheet.
‡
All typical values are at 25°C and with a 3.3-V supply voltage.
driver electrical characteristics over recommended operating conditions (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN
†
TYP
‡
MAX UNIT
V
AB
or
V
YZ
Differential output voltage magnitude See Figure 2 480 650 mV
∆V
AB
or
∆V
YZ
Change in differential output voltage magnitude
between logic states
See Figure 2 –50 50 mV
V
OS(SS)
Steady-state common-mode output voltage 0.8 1.2 V
∆V
OS(SS)
Change in steady-state common-mode output
voltage between logic states
See Figure 3
–50 50 mV
V
OS(PP)
Peak-to-peak common-mode output voltage 150 mV
V
A(OC)
or
V
Y(OC)
Maximum steady-state open-circuit output voltage
See Figure 7
0 2.4 V
V
B(OC)
or
V
Z(OC)
Maximum steady-state open-circuit output voltage
See Figure 7
0 2.4 V
V
P(H)
Voltage overshoot, low-to-high level output
See Figure 5
1.2V
SS
V
V
P(L)
Voltage overshoot, high-to-low level output
See Figure 5
–0.2V
SS
V
I
IH
High-level input current V
IH
= 2 V 0 10 µA
I
IL
Low-level input current V
IL
= 0.8 V 0 10 µA
I
OS
Differential short-circuit output current See Figure 4 24 mA
I
OZ
High-impedance state output current (driver only)
–1.4 V ≤ (V
Y
or V
Z
) ≤ 3.8 V,
Other output at 1.2 V
–15 10 µA
I
O(OFF)
Power-off output current (driver only)
–1.4 V ≤ (V
Y
or V
Z
) ≤ 3.8 V,
V
CC
≤ 1.5 V,
Other output at 1.2 V
–10 10 µA
†
The algebraic convention, in which the least positive (most negative) limit is designated as minimum, is used in this data sheet.
‡
All typical values are at 25°C and with a 3.3-V supply voltage.