Datasheet

www.ti.com
RECOMMENDED OPERATING CONDITIONS
DEVICE ELECTRICAL CHARACTERISTICS
DRIVER ELECTRICAL CHARACTERISTICS
SN65MLVD080
SN65MLVD082
SLLS581B – SEPTEMBER 2003 – REVISED SEPTEMBER 2005
MIN NOM MAX UNIT
V
CC
Supply voltage 3 3.3 3.6 V
V
IH
High-level input voltage 2 V
CC
V
V
IL
Low-level input voltage GND 0.8 V
Voltage at any bus terminal V
A
or V
B
–1.4 3.8 V
|V
ID
| Magnitude of differential input voltage 0.05 V
CC
V
T
A
Operating free-air temperature –40 85 ° C
Maximum junction temperature 140 ° C
over recommended operating conditions unless otherwise noted
PARAMETER TEST CONDITIONS MIN TYP
(1)
MAX UNIT
Driver only RE and DE at V
CC
, R
L
= 50 Ω , All others open 110 140
Both disabled RE at V
CC
, DE at 0 V, R
L
= No Load, All others open 5 8
I
CC
Supply current mA
Both enabled RE at 0 V, DE at V
CC
, R
L
= 50 Ω , C
L
= 15 pF, All others open 140 180
Receiver only RE at 0 V, DE at 0 V, C
L
= 15 pF, All others open 38 50
(1) All typical values are at 25 ° C and with a 3.3-V supply voltage.
over recommended operating conditions unless otherwise noted
PARAMETER TEST CONDITIONS MIN
(1)
TYP
(2)
MAX UNIT
|V
AB
| Differential output voltage magnitude (A, B) 480 650 mV
See Figure 2
Change in differential output voltage magnitude
∆ |V
AB
| –50 50 mV
between logic states (A, B)
V
OS(SS)
Steady-state common-mode output voltage (A, B) 0.8 1.2 V
Change in steady-state common-mode output voltage
∆ V
OS(SS)
See Figure 3 –50 50 mV
between logic states (A, B)
V
OS(PP)
Peak-to-peak common-mode output voltage (A, B) 150 mV
V
A(OC)
Maximum steady-state open-circuit output voltage (A, B) 0 2.4 V
See Figure 7
V
B(OC)
Maximum steady-state open-circuit output voltage (A, B) 0 2.4 V
1.2
V
P(H)
Voltage overshoot, low-to-high level output (A, B) V
V
SS
See Figure 5
–0.2
V
P(L)
Voltage overshoot, high-to-low level output (A, B) V
V
SS
I
IH
High-level input current (D, DE) V
IH
= 2 V to V
CC
10 µA
I
IL
Low-level input current (D, DE) V
IL
= GND to 0.8 V 10 µA
|I
OS
| Differential short-circuit output current magnitude (A, B) See Figure 4 24 mA
C
i
Input capacitance (D, DE) V
I
= 0.4 sin(30E6 π t) + 0.5 V
(3)
5 pF
(1) The algebraic convention, in which the least positive (most negative) limit is designated as minimum is used in this data sheet.
(2) All typical values are at 25 ° C and with a 3.3-V supply voltage.
(3) HP4194A impedance analyzer (or equivalent)
3
Submit Documentation Feedback