Datasheet

www.ti.com
ABSOLUTE MAXIMUM RATINGS
DISSIPATION RATING TABLE
RECOMMENDED OPERATING CONDITIONS
2.4
Ť
V
ID
Ť
2
Ť
V
ID
Ť
2
TIMING REQUIREMENTS
SN65LVDS96
SLLS296H – MAY 1998 – REVISED JULY 2006
over operating free-air temperature range (unless otherwise noted)
(1)
UNIT
V
CC
Supply voltage range
(2)
–0.5 V to 4 V
Voltage range at any terminal (except SHTDN) –0.5 V to V
CC
+ 0.5 V
Voltage range at SHTDN terminal –0.5 V to 5.5 V
Bus pins (Class 3A) 4 KV
Bus pins (Class 2B) 200 V
Electrostatic discharge
(3)
All pins (Class 3A) 3 KV
All pins (Class 2B) 200 V
Continuous total power dissipation See Dissipation Rating Table
T
A
Operating free-air temperature range –40 ° C to 85 ° C
T
stg
Storage temperature range –65 ° C to 150 ° C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 260 ° C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to the GND terminals unless otherwise noted.
(3) This rating is measured using MIL-STD-883C Method, 3015.7.
T
A
≤ 25 ° C DERATING FACTOR
(1)
T
A
= 70 ° C T
A
= 85 ° C
PACKAGE
POWER RATING ABOVE T
A
= 25 ° C POWER RATING POWER RATING
DGG 1316 mW 13.1 mW/ ° C 724 mW 526 mW
(1) This is the inverse of the junction-to-ambient thermal resistance when board-mounted and with no air
flow.
MIN NOM MAX UNIT
V
CC
Supply voltage 3 3.3 3.6 V
V
IH
High-level input voltage SHTDN 2 V
V
IL
Low-level input voltage SHTDN 0.8 V
|V
ID
| Magnitude of differential input voltage 0.1 0.6 V
V
IC
Common-mode input voltage V
V
CC
–0.8
T
A
Operating free-air temperature –40 85 ° C
PARAMETERS MIN NOM MAX UNIT
t
c
(1)
Input clock period 14.7 t
c
50 ns
(1) t
c
is defined as the mean duration of a minimum of 32,000 clock periods.
4
Submit Documentation Feedback