Datasheet
www.ti.com
2.4
V
ID
2
SN65LVDS1050
SLLS343B– APRIL 1999– REVISED APRIL 2003
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted)
(1)
UNIT
Supply voltage range, V
CC
(2)
-0.5 V to 4 V
Voltage range (D, R, DE, RE) -0.5 V to 6 V
Voltage range (Y, Z, A, and B) -0.5 V to 4 V
Electrostatic discharge Y, Z, A, B , and GND
(3)
CLass 3, A:12 kV, B:600 V
All terminals Class 3, A:7 kV, B:500 V
Continuous power dissipation See Dissipation Rating Table
Storage temperature range -65°C to 150°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 250°C
(1)
Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress
ratings only, and functional operation of the device at these or any other condition beyond those indicated under "recommended
operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device
reliability.
(2)
All voltage values, except differential I/O bus voltages are with respect to network ground terminal.
(3)
Tested in accordance with MIL-STD-883C Method 3015.7.
DISSIPATION RATING TABLE
T
A
≤ 25°C POWER RATING DERATING FACTOR ABOVE T
A
=85°C POWER RATING
PACKAGE
T
A
=25°C
PW 774 mW 6.2 mW/°C 402 mW
RECOMMENDED OPERATING CONDITIONS
(1)
MIN NOM MAX UNIT
Supply voltage, V
CC
2.4 2.7 3.6 V
High-level input voltage, V
IH
2 V
Low-level input voltage, V
IL
0.8 V
Magnitude of differential input voltage, |V
ID
| 0.1 0.6 V
Driver output voltage, V
OY
or V
OZ
0 2.4 V
Magnitude of differential output voltage with disabled driver, |V
OD(dis)
| 520 mV
0
Common-mode input voltage, V
IC
(see Figure 5) V
V
CC
-0.8
Operating free-air temperature, T
A
40 85 °C
(1)
The common-mode input voltage, V
IC
, is not fully 644 compliant when V
CC
= 2.4 V.
DEVICE ELECTRICAL CHARACTERISTICS
over recommended operating conditions (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP
(1)
MAX UNIT
Driver and receiver enabled, No receiver load, Driver
12 20
R
L
=100 Ω
Driver enabled, Receiver disabled, R
L
=100 Ω 10 16
I
CC
Supply current mA
Driver disabled, Receiver enabled, No load 3 6
Disabled 0.5 1
(1)
All typical values are at 25°C and with a 2.7-V supply.
3