Datasheet

V
CC
*
|V
ID
|
2
SN65LVCP408
www.ti.com SLLS842A –JUNE 2009–REVISED JUNE 2010
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted)
(1)
UNIT
V
CC
Supply voltage range
(2)
–0.5 V to 6 V
Control inputs, all outputs –0.5 V to (V
CC
+ 0.5 V)
Voltage range
Receiver inputs –0.5 V to 4 V
Human Body Model
(3)
All pins 6 kV
ESD
Charged-Device Model
(4)
All pins 500 V
T
J
Maximum junction temperature See Package Thermal Characteristics Table
Moisture sensitivity level 2
Reflow temperature package soldering, 4 seconds 260°C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values, except differential I/O bus voltages, are with respect to network ground terminal.
(3) Tested in accordance with JEDEC Standard 22, Test Method A114-A.
(4) Tested in accordance with JEDEC Standard 22, Test Method C101.
RECOMMENDED OPERATING CONDITIONS
MIN NOM MAX UNIT
dR Operating data rate 4.25 Gbps
V
CC
Supply voltage 3.135 3.3 3.465 V
V
CC(N)
Supply voltage noise amplitude 10 Hz to 2.125 GHz 20 mV
T
J
Junction temperature 125 °C
T
A
Operating free-air temperature
(1)
Assumes 4x4 thermal via array is -40 85 °C
implemented with 6 layer or greater PCB
otherwise 100LFM airflow is required.
DIFFERENTIAL INPUTS
dR
(in)
≤ 4.25 Gbps 100 1750 mV
PP
Receiver peak-to-peak differential input
V
ID
1.25 Gbps < dR
(in)
≤ 4.25 Gbps 100 1560 mV
PP
voltage
(2)
dR
(in)
> 4.25 Gbps 100 1000 mV
PP
Receiver common-mode Note: for best jitter performance ac
V
ICM
1.5 1.6 V
input voltage coupling is recommended.
CONTROL INPUTS
V
IH
High-level input voltage 2 V
CC
+ 0.3 V
V
IL
Low-level input voltage –0.3 0.8 V
DIFFERENTIAL OUTPUTS
R
L
Differential load resistance 80 100 120 Ω
(1) Maximum free-air temperature operation is allowed as long as the device maximum junction temperature is not exceeded.
(2) Differential input voltage V
ID
is defined as | IN+ – IN– |.
Copyright © 2009–2010, Texas Instruments Incorporated Submit Documentation Feedback 5
Product Folder Link(s): SN65LVCP408