Datasheet

 
    
SLLS447C − OCTOBER 2000 − REVISED AUGUST 2008
3
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
equivalent input and output schematic diagrams
V
CC
A, G, or G Input
1 kΩ
9 V
Input
100 kΩ
V
CC
Output
16 V
Y or Z Output
16 V
20 V
17 V
16 V
16 V
absolute maximum ratings
†
Supply voltage range, V
CC
(see Note 1) −0.3 V to 6 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output voltage range, V
O
, at any bus (steady state) −10 V to 15 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output voltage range, V
O
, at any bus (transient pulse through 100 Ω, see Figure 8) −30 V to 30 V. . . . . . . . . . .
Input voltage range, V
I
, at any A, G, or G terminal −0.5 V to V
CC
+ 0.5 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electrostatic discharge: Human body model (see Note 2) Y, Z, and GND 12 kV. . . . . . . . . . . . . . . . . . . . .
All pins 5 kV. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Charged-device model (see Note 3) All pins 1 kV. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
stg
−65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous power dissipation See Dissipation Rating Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 260°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
†
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential I/O bus voltages, are with respect to GND.
2. Tested in accordance with JEDEC standard 22, Test Method A114−A.
3. Tested in accordance with JEDEC standard 22, Test Method C101.
DISSIPATION RATING TABLE
PACKAGE
JEDEC
BOARD
MODEL
T
A
≤ 25°C
POWER RATING
DERATING FACTOR
‡
ABOVE T
A
= 25°C
T
A
= 70°C
POWER RATING
T
A
= 85°C
POWER RATING
16-PIN DW
Low K 1200 mW 9.6 mW/°C 769 mW 625 mW
16-PIN DW
High K 2240 mW 17.9 mW/°C 1434 mW 1165 mW
20-PIN DW
Low K 1483 mW 11.86 mW/°C 949 mW 771 mW
20-PIN DW
High K 2753 mW 22 mW/°C 1762 mW 1432 mW
16-PIN N Low K 1150 mW 9.2 mW/°C 736 mW 598 mW
‡
This is the inverse of the junction-to-ambient thermal resistance when board-mounted with no air flow.