Datasheet

SN65HVD72
SN65HVD75
SN65HVD78
www.ti.com SLLSE11C –MARCH 2012–REVISED SEPTEMBER 2013
ABSOLUTE MAXIMUM RATINGS
(1)
VALUE
UNIT
MIN MAX
Supply Voltage, V
CC
–0.5 5.5 V
Voltage range at A or B Inputs –13 16.5 V
Input voltage range at any logic pin –0.3 5.7 V
Voltage input range, transient pulse, A and B, through 100Ω –100 100 V
Receiver Output Current –24 24 mA
Junction Temperature, T
J
170 °C
Storage Temperature, -65 150 °C
Continuous total power dissipation See the Thermal Characteristics table
IEC 61000-4-2 ESD (Air-Gap Discharge), bus terminals and GND
(2)
±12 kV
IEC 61000-4-2 ESD (Contact Discharge), bus terminals and GND ±12 kV
IEC 61000-4-4 EFT (Fast transient or burst) bus terminals and GND ±4 kV
IEC 60749-26 ESD (Human Body Model), bus terminals and GND ±15 kV
JEDEC Standard 22, Test Method A114 (Human Body Model), all pins ±8 kV
JEDEC Standard 22, Test Method C101 (Charged Device Model), all pins ±1.5 kV
JEDEC Standard 22, Test Method A115 (Machine Model), all pins ±300 V
(1) Stresses beyond those listed under "absolute maximum ratings " may cause permanent damage to the device. These are stress ratings
only and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) By inference from contact discharge results, see the Application Information section
RECOMMENDED OPERATING CONDITIONS
MIN NOM MAX UNIT
V
CC
Supply voltage 3 3.3 3.6 V
V
I
Input voltage at any bus terminal (separately or common mode)
(1)
–7 12 V
V
IH
High-level input voltage (Driver, driver enable, and receiver enable inputs) 2 V
CC
V
V
IL
Low-level input voltage (Driver, driver enable, and receiver enable inputs) 0 0.8 V
V
ID
Differential input voltage –12 12 V
I
O
Output current, Driver –60 60 mA
I
O
Output current, Receiver –8 8 mA
R
L
Differential load resistance 54 60 Ω
C
L
Differential load capacitance 50 pF
HVD72 250 kbps
Signaling rate HVD75 20 Mbps
1/t
UI
HVD78 50 Mbps
T
A
(2)
Operating free-air temperature (See the application section for thermal information) –40 125 °C
T
J
Junction Temperature –40 150 °C
(1) The algebraic convention, in which the least positive (most negative) limit is designated as minimum is used in this data sheet.
(2) Operation is specified for internal (junction) temperatures up to 150°C. Self-heating due to internal power dissipation should be
considered for each application. Maximum junction temperature is internally limited by the thermal shut-down (TSD) circuit which
disables the driver outputs when the junction temperature reaches 170°C.
Copyright © 2012–2013, Texas Instruments Incorporated Submit Documentation Feedback 3
Product Folder Links: SN65HVD72 SN65HVD75 SN65HVD78